Mc-leod Original Street Twin User Manual download pdf

McLeod Street Twin Clutch System

Installation Instructions

All assemblies should be balanced to the flywheel you are replacing.

Street Twin assemblies are not Pre-Balanced from the factory.

Allow 500 city miles (1200 shift cycles) break-in period before hard driving.

When performance driving, all traction control devices

1) Inspect clutch assembly before disassembly. See Figure. 1. Note alignment marks.

must be turned off or clutch slippage will occur.

Figure 1

2) Unbolt pressure plate by removing six nuts. Note alignment mark (blue paint) on pressure

plate, floater and flywheel. These must be in same position when re-assembling

components.

1 2 3 4

1 McLeod Street Twin Clutch System Installation Instructions All assemblies should be balanced to the flywheel you are replacing. Street Twin assemb

Page 2

2 3) Remove top disc and alignment tool. Notice the hub on the disc is cupped toward the transmission. Also note the “Flywheel Side” sticker on the

Page 3

3 6) Inspect the crankshaft at this time. Remove any dirt from the crank and clean the pilot hole. A wire brush can be used. Inspect the pilot

4 Important Clutch Installation Hints The following check list is a reminder of the necessary inspection points and precautions required to insure a

No comments

Mc-leod Original Street Twin User Manual